8 Gang Switch Panel for Automotive and Off Road

Optimize your accessory management with our 8 Gang Switch Panel, designed to centralize control and simplify setup. Its versatile on/off buttons also switch to solid, strobe, or momentary mode. Easy to install with all necessary hardware included, this universal panel is adventure-ready. It comes with a dual slide plug in the two side outlet box for added convenience.

Key Features

• Upgrade 3 Lighting Modes: Each button can be programmed to be solid, strobe, or momentary. Our 8-gang switch panel solves the problem of your switch being too single when driving off-road and provides a clean and safe solution to power and control your accessories.
• Used in Various Models: This compact, universal control system is designed for use in any vehicle, power sports, and boat with 12-24V DC.
• Less than 5 Minutes Installation: No complicated wiring, the harness can connect the LED lights or accessories easily.
• High Material: Made from high Mix PP-ABS. Wires are wrapped in high-temp abrasion-resistant nylon braided sleeving. With a circuit breaker, reverse polarity protection, and temperature management system, no need to worry about over-current, shorts, or overheating (even 200°max).

Specification

• 3 Switch Mode: Solid, Strobe, Momentary
• Operating Voltage: 12-24V
• Maximum Current: 60A
• Rated Voltage: 12V 20A / 24V 10A
• Working at 12 Volts: Max Rate Power 960W
• Working at 24 Volts: Max Rate Power 1920W
• Working Temperature: -40℃ - +105℃
• Waterproof Rate: IP67
• 8-Gang Control Panel Without Battery, USB-Type C Interface(Fixing method: Double-sided Tape or Metal Bracket)
• Fuse Box, Positive and Negative Power Supply Wiring (+ protection switch) + ACC Wiring Port (with fuse), Fixing Method: Tie or Metal Bracket

Fitment

For use in any vehicle, Powersports, and boat with 12-24V DC. Such as for jeep, Ford, ranger, 4Runner, SUV, Pickup, Truck, Van, RV, ATV, UTV, SXS, Polaris, RZR, Can-Am, 4x4, Car, Boat, etc. Due to its small footprint of it, the switch can be installed on the dashboard, overhead sunglasses holder, center console, dash panel, etc. The control box can be installed in the engine bay or other places.

Package Include

• 1 x 8 Gang Switch Panel
• 1 x Circult Control Box
• 5 x Mounting Brackets
• 1 x 100A Circuit Breaker
• 1 x Cable
• 1 x USB Calbe
• 1 x Fuse Jumper
• 1 x ACC Extend Wire
• 1 x Accessories Package
• 1 x Sticker
• 1 x Installation Manual